diff options
Diffstat (limited to 'Documentation/devicetree/bindings/serial')
| -rw-r--r-- | Documentation/devicetree/bindings/serial/mtk-uart.txt | 13 | ||||
| -rw-r--r-- | Documentation/devicetree/bindings/serial/st,stm32-usart.txt | 1 |
2 files changed, 12 insertions, 2 deletions
diff --git a/Documentation/devicetree/bindings/serial/mtk-uart.txt b/Documentation/devicetree/bindings/serial/mtk-uart.txt index c6b5262eb352..6fdffb735fb9 100644 --- a/Documentation/devicetree/bindings/serial/mtk-uart.txt +++ b/Documentation/devicetree/bindings/serial/mtk-uart.txt @@ -23,7 +23,12 @@ Required properties: - reg: The base address of the UART register bank. -- interrupts: A single interrupt specifier. +- interrupts: + index 0: an interrupt specifier for the UART controller itself + index 1: optional, an interrupt specifier with edge sensitivity on Rx pin to + support Rx in-band wake up. If one would like to use this feature, + one must create an addtional pinctrl to reconfigure Rx pin to normal + GPIO before suspend. - clocks : Must contain an entry for each entry in clock-names. See ../clocks/clock-bindings.txt for details. @@ -39,7 +44,11 @@ Example: uart0: serial@11006000 { compatible = "mediatek,mt6589-uart", "mediatek,mt6577-uart"; reg = <0x11006000 0x400>; - interrupts = <GIC_SPI 51 IRQ_TYPE_LEVEL_LOW>; + interrupts = <GIC_SPI 51 IRQ_TYPE_LEVEL_LOW>, + <GIC_SPI 52 IRQ_TYPE_EDGE_FALLING>; clocks = <&uart_clk>, <&bus_clk>; clock-names = "baud", "bus"; + pinctrl-names = "default", "sleep"; + pinctrl-0 = <&uart_pin>; + pinctrl-1 = <&uart_pin_sleep>; }; diff --git a/Documentation/devicetree/bindings/serial/st,stm32-usart.txt b/Documentation/devicetree/bindings/serial/st,stm32-usart.txt index 9d3efed55deb..a6b19485c9dc 100644 --- a/Documentation/devicetree/bindings/serial/st,stm32-usart.txt +++ b/Documentation/devicetree/bindings/serial/st,stm32-usart.txt @@ -13,6 +13,7 @@ Required properties: - clocks: The input clock of the USART instance Optional properties: +- resets: Must contain the phandle to the reset controller. - pinctrl: The reference on the pins configuration - st,hw-flow-ctrl: bool flag to enable hardware flow control. - rs485-rts-delay, rs485-rx-during-tx, rs485-rts-active-low, |