diff options
Diffstat (limited to 'drivers/net/phy/Kconfig')
| -rw-r--r-- | drivers/net/phy/Kconfig | 234 |
1 files changed, 0 insertions, 234 deletions
diff --git a/drivers/net/phy/Kconfig b/drivers/net/phy/Kconfig index c69cc806f064..20252d7487db 100644 --- a/drivers/net/phy/Kconfig +++ b/drivers/net/phy/Kconfig @@ -3,240 +3,6 @@ # PHY Layer Configuration # -menuconfig MDIO_DEVICE - tristate "MDIO bus device drivers" - help - MDIO devices and driver infrastructure code. - -if MDIO_DEVICE - -config MDIO_BUS - tristate - default m if PHYLIB=m - default MDIO_DEVICE - help - This internal symbol is used for link time dependencies and it - reflects whether the mdio_bus/mdio_device code is built as a - loadable module or built-in. - -if MDIO_BUS - -config MDIO_DEVRES - tristate - -config MDIO_ASPEED - tristate "ASPEED MDIO bus controller" - depends on ARCH_ASPEED || COMPILE_TEST - depends on OF_MDIO && HAS_IOMEM - help - This module provides a driver for the independent MDIO bus - controllers found in the ASPEED AST2600 SoC. This is a driver for the - third revision of the ASPEED MDIO register interface - the first two - revisions are the "old" and "new" interfaces found in the AST2400 and - AST2500, embedded in the MAC. For legacy reasons, FTGMAC100 driver - continues to drive the embedded MDIO controller for the AST2400 and - AST2500 SoCs, so say N if AST2600 support is not required. - -config MDIO_BCM_IPROC - tristate "Broadcom iProc MDIO bus controller" - depends on ARCH_BCM_IPROC || COMPILE_TEST - depends on HAS_IOMEM && OF_MDIO - default ARCH_BCM_IPROC - help - This module provides a driver for the MDIO busses found in the - Broadcom iProc SoC's. - -config MDIO_BCM_UNIMAC - tristate "Broadcom UniMAC MDIO bus controller" - depends on HAS_IOMEM - help - This module provides a driver for the Broadcom UniMAC MDIO busses. - This hardware can be found in the Broadcom GENET Ethernet MAC - controllers as well as some Broadcom Ethernet switches such as the - Starfighter 2 switches. - -config MDIO_BITBANG - tristate "Bitbanged MDIO buses" - help - This module implements the MDIO bus protocol in software, - for use by low level drivers that export the ability to - drive the relevant pins. - - If in doubt, say N. - -config MDIO_BUS_MUX - tristate - depends on OF_MDIO - help - This module provides a driver framework for MDIO bus - multiplexers which connect one of several child MDIO busses - to a parent bus. Switching between child busses is done by - device specific drivers. - -config MDIO_BUS_MUX_BCM_IPROC - tristate "Broadcom iProc based MDIO bus multiplexers" - depends on OF && OF_MDIO && (ARCH_BCM_IPROC || COMPILE_TEST) - select MDIO_BUS_MUX - default ARCH_BCM_IPROC - help - This module provides a driver for MDIO bus multiplexers found in - iProc based Broadcom SoCs. This multiplexer connects one of several - child MDIO bus to a parent bus. Buses could be internal as well as - external and selection logic lies inside the same multiplexer. - -config MDIO_BUS_MUX_GPIO - tristate "GPIO controlled MDIO bus multiplexers" - depends on OF_GPIO && OF_MDIO - select MDIO_BUS_MUX - help - This module provides a driver for MDIO bus multiplexers that - are controlled via GPIO lines. The multiplexer connects one of - several child MDIO busses to a parent bus. Child bus - selection is under the control of GPIO lines. - -config MDIO_BUS_MUX_MESON_G12A - tristate "Amlogic G12a based MDIO bus multiplexer" - depends on ARCH_MESON || COMPILE_TEST - depends on OF_MDIO && HAS_IOMEM && COMMON_CLK - select MDIO_BUS_MUX - default m if ARCH_MESON - help - This module provides a driver for the MDIO multiplexer/glue of - the amlogic g12a SoC. The multiplexers connects either the external - or the internal MDIO bus to the parent bus. - -config MDIO_BUS_MUX_MMIOREG - tristate "MMIO device-controlled MDIO bus multiplexers" - depends on OF_MDIO && HAS_IOMEM - select MDIO_BUS_MUX - help - This module provides a driver for MDIO bus multiplexers that - are controlled via a simple memory-mapped device, like an FPGA. - The multiplexer connects one of several child MDIO busses to a - parent bus. Child bus selection is under the control of one of - the FPGA's registers. - - Currently, only 8/16/32 bits registers are supported. - -config MDIO_BUS_MUX_MULTIPLEXER - tristate "MDIO bus multiplexer using kernel multiplexer subsystem" - depends on OF_MDIO - select MULTIPLEXER - select MDIO_BUS_MUX - help - This module provides a driver for MDIO bus multiplexer - that is controlled via the kernel multiplexer subsystem. The - bus multiplexer connects one of several child MDIO busses to - a parent bus. Child bus selection is under the control of - the kernel multiplexer subsystem. - -config MDIO_CAVIUM - tristate - -config MDIO_GPIO - tristate "GPIO lib-based bitbanged MDIO buses" - depends on MDIO_BITBANG - depends on GPIOLIB || COMPILE_TEST - help - Supports GPIO lib-based MDIO busses. - - To compile this driver as a module, choose M here: the module - will be called mdio-gpio. - -config MDIO_HISI_FEMAC - tristate "Hisilicon FEMAC MDIO bus controller" - depends on HAS_IOMEM && OF_MDIO - help - This module provides a driver for the MDIO busses found in the - Hisilicon SoC that have an Fast Ethernet MAC. - -config MDIO_I2C - tristate - depends on I2C - help - Support I2C based PHYs. This provides a MDIO bus bridged - to I2C to allow PHYs connected in I2C mode to be accessed - using the existing infrastructure. - - This is library mode. - -config MDIO_IPQ4019 - tristate "Qualcomm IPQ4019 MDIO interface support" - depends on HAS_IOMEM && OF_MDIO - help - This driver supports the MDIO interface found in Qualcomm - IPQ40xx series Soc-s. - -config MDIO_IPQ8064 - tristate "Qualcomm IPQ8064 MDIO interface support" - depends on HAS_IOMEM && OF_MDIO - depends on MFD_SYSCON - help - This driver supports the MDIO interface found in the network - interface units of the IPQ8064 SoC - -config MDIO_MOXART - tristate "MOXA ART MDIO interface support" - depends on ARCH_MOXART || COMPILE_TEST - help - This driver supports the MDIO interface found in the network - interface units of the MOXA ART SoC - -config MDIO_MSCC_MIIM - tristate "Microsemi MIIM interface support" - depends on HAS_IOMEM - select MDIO_DEVRES - help - This driver supports the MIIM (MDIO) interface found in the network - switches of the Microsemi SoCs; it is recommended to switch on - CONFIG_HIGH_RES_TIMERS - -config MDIO_MVUSB - tristate "Marvell USB to MDIO Adapter" - depends on USB - select MDIO_DEVRES - help - A USB to MDIO converter present on development boards for - Marvell's Link Street family of Ethernet switches. - -config MDIO_OCTEON - tristate "Octeon and some ThunderX SOCs MDIO buses" - depends on (64BIT && OF_MDIO) || COMPILE_TEST - depends on HAS_IOMEM - select MDIO_CAVIUM - help - This module provides a driver for the Octeon and ThunderX MDIO - buses. It is required by the Octeon and ThunderX ethernet device - drivers on some systems. - -config MDIO_SUN4I - tristate "Allwinner sun4i MDIO interface support" - depends on ARCH_SUNXI || COMPILE_TEST - help - This driver supports the MDIO interface found in the network - interface units of the Allwinner SoC that have an EMAC (A10, - A12, A10s, etc.) - -config MDIO_THUNDER - tristate "ThunderX SOCs MDIO buses" - depends on 64BIT - depends on PCI - select MDIO_CAVIUM - help - This driver supports the MDIO interfaces found on Cavium - ThunderX SoCs when the MDIO bus device appears as a PCI - device. - -config MDIO_XGENE - tristate "APM X-Gene SoC MDIO bus controller" - depends on ARCH_XGENE || COMPILE_TEST - help - This module provides a driver for the MDIO busses found in the - APM X-Gene SoC's. - -endif -endif - config PHYLINK tristate depends on NETDEVICES |