arm: rpi: Sync rpi dts files from Linux

Sync these files, obtained from Linux v5.15.

This adds a devicetree file for rpi_4 which was not there before.

Testing shows no change so far as I can see:
- boots to U-Boot prompt on rpi0, rpi2
- boots to distro on rpi3
- boots to distro on rpi4

I am assuming that syncing with Linux is safe, but the maintainer should
know for sure.

Signed-off-by: Simon Glass <sjg@chromium.org>

1 files changed, 18 insertions, 2 deletions

diff --git a/arch/arm/dts/bcm2835-rpi-zero-w.dts b/arch/arm/dts/bcm2835-rpi-zero-w.dts
index ba0167df6c5..33b2b77aa47 100644
--- a/arch/arm/dts/bcm2835-rpi-zero-w.dts
+++ b/arch/arm/dts/bcm2835-rpi-zero-w.dts
@@ -12,14 +12,19 @@
 	compatible = "raspberrypi,model-zero-w", "brcm,bcm2835";
 	model = "Raspberry Pi Zero W";
 
+	memory@0 {
+		device_type = "memory";
+		reg = <0 0x20000000>;
+	};
+
 	chosen {
 		/* 8250 auxiliary UART instead of pl011 */
 		stdout-path = "serial1:115200n8";
 	};
 
 	leds {
-		act {
-			gpios = <&gpio 47 GPIO_ACTIVE_HIGH>;
+		led-act {
+			gpios = <&gpio 47 GPIO_ACTIVE_LOW>;
 		};
 	};
 
@@ -100,12 +105,16 @@
 
 &hdmi {
 	hpd-gpios = <&gpio 46 GPIO_ACTIVE_LOW>;
+	power-domains = <&power RPI_POWER_DOMAIN_HDMI>;
+	status = "okay";
 };
 
 &sdhci {
 	#address-cells = <1>;
 	#size-cells = <0>;
+	pinctrl-names = "default";
 	pinctrl-0 = <&emmc_gpio34 &gpclk2_gpio43>;
+	bus-width = <4>;
 	mmc-pwrseq = <&wifi_pwrseq>;
 	non-removable;
 	status = "okay";
@@ -116,6 +125,13 @@
 	};
 };
 
+&sdhost {
+	pinctrl-names = "default";
+	pinctrl-0 = <&sdhost_gpio48>;
+	bus-width = <4>;
+	status = "okay";
+};
+
 &uart0 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&uart0_gpio32 &uart0_ctsrts_gpio30>;