1 files changed, 0 insertions, 45 deletions
diff --git a/Documentation/devicetree/bindings/gpio/gpio-tz1090-pdc.txt b/Documentation/devicetree/bindings/gpio/gpio-tz1090-pdc.txt
deleted file mode 100644
index 528f5ef5a893..000000000000
--- a/Documentation/devicetree/bindings/gpio/gpio-tz1090-pdc.txt
+++ /dev/null
@@ -1,45 +0,0 @@
-ImgTec TZ1090 PDC GPIO Controller
-
-Required properties:
-- compatible: Compatible property value should be "img,tz1090-pdc-gpio".
-
-- reg: Physical base address of the controller and length of memory mapped
-  region. This starts at and cover the SOC_GPIO_CONTROL registers.
-
-- gpio-controller: Specifies that the node is a gpio controller.
-
-- #gpio-cells: Should be 2. The syntax of the gpio specifier used by client
-  nodes should have the following values.
-     <[phandle of the gpio controller node]
-      [PDC gpio number]
-      [gpio flags]>
-
-  Values for gpio specifier:
-  - GPIO number: a value in the range 0 to 6.
-  - GPIO flags: bit field of flags, as defined in <dt-bindings/gpio/gpio.h>.
-    Only the following flags are supported:
-      GPIO_ACTIVE_HIGH
-      GPIO_ACTIVE_LOW
-
-Optional properties:
-- gpio-ranges: Mapping to pin controller pins (as described in
-  Documentation/devicetree/bindings/gpio/gpio.txt)
-
-- interrupts: Individual syswake interrupts (other GPIOs cannot interrupt)
-
-
-Example:
-
-	pdc_gpios: gpio-controller@2006500 {
-		gpio-controller;
-		#gpio-cells = <2>;
-
-		compatible = "img,tz1090-pdc-gpio";
-		reg = <0x02006500 0x100>;
-
-		interrupt-parent = <&pdc>;
-		interrupts =	<8  IRQ_TYPE_NONE>,	/* Syswake 0 */
-				<9  IRQ_TYPE_NONE>,	/* Syswake 1 */
-				<10 IRQ_TYPE_NONE>;	/* Syswake 2 */
-		gpio-ranges = <&pdc_pinctrl 0 0 7>;
-	};